G19 Aluminum Rail
G19 DIY Rail for 3D printed pistols, manufactured by Riptide Rail.
Available to US persons except New Jersey residents. Does not ship internationally.
Note: your jurisdiction may require you to be a licensed FFL or licensed gunsmith to purchase this product.
add to cart
G19 DIY Rail Kit - Aluminum
Riptide Rails' kits are ready to use and easy to install! The screws are already ground to the recommended 7mm length and the front pin doesn't require a hammer to install!
Compatible with FMDA G19 with DIY rail system
Machined from 6061 aluminum
Includes all necessary hardware and hex key (one free hex key per screw type per order)
The FMDA G19 is designed to use a G26 locking block. If you have a G19 locking block, you will have to trim the front rail block or the G19 locking block to allow proper clearance between the two parts
Ream screw holes in frame to .0995" (#40)
Ream front rail block pin hole in frame to .125" (1/8")
Start all screws with fingers to avoid cross-threading
(1) Front Rail Block
(1) Rear Left Rail
(1) Rear Right Rail
(1) 1.5mm Hex Key
(4) M2.5 x 7mm BHCS (Already ground to length)
(1) 1/8" x 1-1/16" Solid Pin (No hammering necessary)*
(1) 3D-Printed RailBlock
*Note: Riptide Rails' pin diameters may differ from the developers' original design but are still compatible with the original 3D-printed design.